User Guide (pdf)

Connecting the Scanner to a Computer

Connect the CR-135i II/CR-190i II to a computer as follows. Make sure

to install the software before connecting the scanner to a computer.

• If you connect the computer and turn ON the CR-135i II/CR-190i II

before installing the software, the following wizard screen appears. If

this happens, click [Cancel], turn OFF the CR-135i II/CR-190i II, and

then install the software.

The following wizard screen is an example in Windows 7. When a

similar wizard screen appears in Windows 8.1/10, click [Cancel].

A Install the software

Install the Scanning Utility for CR-135i/CR-190i in the setup disc

provided with the CR-135i II/CR-190i II. (See “Installing the

Software,” on p. 18.)

B Connect the scanner to a computer

Connect the CR-135i II/CR-190i II and the computer with a USB.

(See “Connecting the Scanner to a Computer,” on p. 19.)

C Turn ON the power

Turn ON the power of the CR-135i II/CR-190i II. (See “Turning ON

the Power,” on p. 20.)

D Automatically installing the device driver

The device driver is installed automatically when Windows

recognizes the CR-135i II/CR-190i II as new hardware. (See

p. 21.)

Wizard Screen (Windows 7)