Owner's Manual

1-10
Chapter 1 Before You Start Using the Scanner
3. Names and Functions of Parts
The names and functions of the DR-6050C/7550C/9050C parts are shown below.
Front View, Feeder Inlet, and Eject Outlet
a Upper Unit
Open when cleaning the rollers or paper jams. (See p. 3-23.)
b Imprinter Cover
Open when replacing the ink cartridge in the optional
imprinter or when cleaning the imprinter. (See p. 5-13.)
c Document Eject Tray
Scanned documents are output here. (See p. 3-10.)
d Control Panel (See p. 1-12.)
e Power Switch
Turns the scanner ON and OFF. (See p. 3-2.)
f Document Eject Tray Extension
Open the Document Eject Tray Extension when
documents look like they are going to fall off of the eject
tray. (See p. 3-10.)
g Eject Paper Stoppers
Adjust to fit the length of documents, to avoid document
spillage. (See p. 3-10.)
h Document Guides
Adjust to fit the width of documents, so that ejected
documents stack neatly. (See p. 3-10.)
i Document Guides
Adjust to fit the width of documents. (See p. 3-8 and
p. 3-9.)
+ Document Guide Lock Lever
Locks the Document Guides. (See p. 3-9.)
, Document Feed Tray
Load documents to be scanned here. (See p. 3-6.)
- Document Feeder Tray Extension / Extension Wire
Extend as needed to fit the length of the documents. (See
p. 3-7.)
CAUTION
Do not open the imprinter cover if the optional imprinter is not installed.