Instruction Guide
Table Of Contents
- ScanFront300/300P INSTRUCTIONS
- Introduction
- Table of Contents
- Chapter 1 Before Use
- Chapter 2 Handling
- Chapter 3 ScanFront Setup
- Chapter 4 ScanFront Service
- Chapter 5 Operating Procedures
- Chapter 6 Web Menu (Administrator Mode)
- Chapter 7 ScanFront Administration Tool
- Chapter 8 Web Menu (User Mode)
- Chapter 9 Maintenance
- Chapter 10 Troubleshooting
- Chapter 11 Appendices
6-29
Chapter 6 Web Menu (Administrator Mode)
6. Device Configuration
From the Device Configuration screen, you can configure the scanner settings.
a Network Setting
Confirm or change the network settings of the scanner.
(See “Network Setting” on p. 6-30.)
b Language/Timezone
Configure the language displayed on the touch panel and
the region where it is being used. (See “Language/
Timezone” on p. 6-30.)
IMPORTANT
The time zone setting also effects the time stamp on sent e-mail.
c Device Operation
Configure the setlings for [Display off], [Auto Logout]
and [Low Power Mode]. (See “Device Operation” on
p. 6-31.)
d Login Options
Select the type of screen that appears when users log in.
(See “Login Options” on p. 6-31.)
e Administrator Settings
Set the password and e-mail address of the Administrator.
(See “Administrator Settings” on p. 6-32.)
IMPORTANT
The e-mail address of the Administrator is used as the
originating address when a user without a registered e-mail
address sends an e-mail message.
a
b
c
d
e
a
b
c
d
e