Instruction Guide

6-37
Chapter 6 Web Menu (Administrator Mode)
❏ NTP Server
You can configure the NTP server settings to synchronize
the ScanFront with the correct time.
NTP Server Setting
Select this check box to synchronize with the NTP server.
NTP Server(primary)
Enter the host name or IP address of the main NTP server.
NTP Server(secondary)
Enter the host name or IP address of the secondary NTP
server.
IMPORTANT
The NTP server and ScanFront are synchronized when [OK] is
clicked on the settings screen to complete the settings and
every time the ScanFront is started.
❏ ScanFront Service Server
When a ScanFront Service Server (i.e., a computer on
which ScanFront Service is installed) exists on the
network, use this to specify the host name of the server and
the port number used for transmission.
Hint
ScanFront Service uses port number 50000 to communicate
with the ScanFront by default. If the default port number used by
ScanFront Service has been changed (see p. 4-6), make sure
to specify the changed port number here.