Instruction Guide
Table Of Contents
- ScanFront300/300P INSTRUCTIONS
- Introduction
- Table of Contents
- Chapter 1 Before Use
- Chapter 2 Handling
- Chapter 3 ScanFront Setup
- Chapter 4 ScanFront Service
- Chapter 5 Operating Procedures
- Chapter 6 Web Menu (Administrator Mode)
- Chapter 7 ScanFront Administration Tool
- Chapter 8 Web Menu (User Mode)
- Chapter 9 Maintenance
- Chapter 10 Troubleshooting
- Chapter 11 Appendices
10-13
Chapter 10 Troubleshooting
5. Initializing ScanFront
Initialize the ScanFront to protect user information when you submit the ScanFront for repairs or when you want to delete the user
information because, for example, you are changing the operating location. This initializes all the information registered to the
ScanFront, including user information, address books, and job buttons.
IMPORTANT
Initializing the ScanFront deletes all registered information. Always back up the data prior to initialization.
1. Log in to the Administrator setting screen.
2. Press the [Format ScanFront 300] button.
3. Confirm the message, and then press [Yes].
4. Confirm the message, and then press [Yes].
5. Confirm the message and press [Yes] to perform
initialization, and the scanner will turn OFF.
6. Turn the scanner ON, and set up the scanner again.