Instruction Guide
Table Of Contents
- ScanFront300/300P INSTRUCTIONS
- Introduction
- Table of Contents
- Chapter 1 Before Use
- Chapter 2 Handling
- Chapter 3 ScanFront Setup
- Chapter 4 ScanFront Service
- Chapter 5 Operating Procedures
- Chapter 6 Web Menu (Administrator Mode)
- Chapter 7 ScanFront Administration Tool
- Chapter 8 Web Menu (User Mode)
- Chapter 9 Maintenance
- Chapter 10 Troubleshooting
- Chapter 11 Appendices
2-5
Chapter 2 Handling
❏ Feed Selection Lever
Change the position of the lever to the desired feed method
for the document.
Page Separation ON
Move the lever downward to separate a stack of documents
one page at a time in order to continuously feed the
documents.
Page Separation OFF
Move the lever upward to feed a document with multiple
pages attached together such as an invoice one page at a
time without separating the pages.
IMPORTANT
Moving the lever upward (Page Separation OFF) and then
scanning a stack of documents will cause multiple pages to be
fed at the same time.
❏ USB Port
You can insert a USB memory device to store image files.
You can also connect a USB keyboard and USB mouse to
operate the ScanFront.
IMPORTANT
• The scanner will not start if you turn the power ON while a USB
memory device is inserted. Insert the USB memory device
after the scanner has started up.
• Use USB memory that is not write-protected. If the USB
memory is write-protected, data cannot be written to the USB
memory.
• This scanner does not support USB memory equipped with
password security, data encryption, or functions other than
data storage.
• Make sure that the USB memory has sufficient space to store
images.
Feed selection lever
Page Separation
ON
Page Separation
OFF
USB Memory