Instruction Guide
Table Of Contents
- ScanFront300/300P INSTRUCTIONS
- Introduction
- Table of Contents
- Chapter 1 Before Use
- Chapter 2 Handling
- Chapter 3 ScanFront Setup
- Chapter 4 ScanFront Service
- Chapter 5 Operating Procedures
- Chapter 6 Web Menu (Administrator Mode)
- Chapter 7 ScanFront Administration Tool
- Chapter 8 Web Menu (User Mode)
- Chapter 9 Maintenance
- Chapter 10 Troubleshooting
- Chapter 11 Appendices
![](/manual/canon/imageformula-scanfront-300/instruction-guide-english/images/img-27.png)
2-6
Chapter 2 Handling
3. Placing Documents
When placing documents into the scanner, place them face down into the tray with the top edge of the document at the bottom of
tray.
❏ Placing a Document
Follow the procedure below to place a document.
1. Adjust the document guides to be wider than the
width of the document.
2. Fan the document to offset the pages so that the top
edge of the first page is the lowest.
3. Place the document face down with its top edge at
the bottom of the tray.
4. Adjust the document guides to fit the width of the
document.