Instruction Guide
Table Of Contents
- ScanFront300/300P INSTRUCTIONS
- Introduction
- Table of Contents
- Chapter 1 Before Use
- Chapter 2 Handling
- Chapter 3 ScanFront Setup
- Chapter 4 ScanFront Service
- Chapter 5 Operating Procedures
- Chapter 6 Web Menu (Administrator Mode)
- Chapter 7 ScanFront Administration Tool
- Chapter 8 Web Menu (User Mode)
- Chapter 9 Maintenance
- Chapter 10 Troubleshooting
- Chapter 11 Appendices
2-8
Chapter 2 Handling
❏ Placing a Card
When you want to scan a card, follow the procedure below
to place the card.
1. Move the feed selection lever upward (OFF).
IMPORTANT
When scanning cards, set the feed selection lever to OFF and
make sure to scan the cards one at a time.
2. Adjust the document guides to match the width of the
card.
3. Place the card face down with the top edge at the
bottom of the tray.
CAUTION
• A card placed into the document feed tray in the portrait
orientation may not be output properly because a load is
placed on it during feeding. Furthermore, removing a card that
has caused a feeding error may damage the card, so make
sure to correctly insert the card.
• Pull the lock lever and open the panel unit before removing a
placed card. Inserting a finger into the scanner while the panel
unit is closed may result in an injury.
Lock lever