Instruction Guide
Table Of Contents
- ScanFront300/300P INSTRUCTIONS
- Introduction
- Table of Contents
- Chapter 1 Before Use
- Chapter 2 Handling
- Chapter 3 ScanFront Setup
- Chapter 4 ScanFront Service
- Chapter 5 Operating Procedures
- Chapter 6 Web Menu (Administrator Mode)
- Chapter 7 ScanFront Administration Tool
- Chapter 8 Web Menu (User Mode)
- Chapter 9 Maintenance
- Chapter 10 Troubleshooting
- Chapter 11 Appendices
3-11
Chapter 3 ScanFront Setup
❏ Roller Counter Reset
Reset the counter after replacing the feed roller when the
scanner no longer feeds properly. For details, see
“Replacing the Rollers and Document Holding Guide” on
p. 9-8.
❏ Format ScanFront 300
Initialize the ScanFront 300 clears all the settings
registered to the ScanFront.
Initialize the ScanFront 300 at the following times. For
details, see “Initializing ScanFront” on p. 10-13.
When submitting the ScanFront for repairs
Before you submit the ScanFront for repairs, initialize the
ScanFront to protect the saved user information.
When changing the operating environment
Delete all the user information registered on the ScanFront
when, for instance, the users have changed because you
have changed the installation location.
❏ Touch Panel Adjustment
You can adjust the touch panel when it does not operate as
expected. For details, see “Adjusting the Touch Panel” on
p. 10-11.