Operation Guide

Your job is not sent to the selected destination on the
printing system
Introduction
When you use the +job button to send a job, the selected destination on the printing system is
not reached.
The job goes to another destination on the printing system.
The same happens if you use drag and drop to a destination in the printer view.
Explanation
On the printing system the default destination for incoming jobs can be set in the Workflow
profile.
This setting overrules any destination selected in PRISMAsync Remote Manager.
Solution
To solve this problem you need to change the default destination in the current workflow profile.
This can be changed in [System] -> [Setup] -> [Workflow profile] -> [Destination of print job] on
the control panel of the printing system.
Change the setting of [Destination of print job] to the value [as in job].
Your job is not sent to the selected destination on the printing system
Chapter 5 - Problem solving
43
PRISMAsync Remote Manager