User manual

Problems with the printing quality
The surface of the paper is dirty
Cause Corrective Action
The Paper Retainer is soiled. Clean the Paper Retainer .
( → P .647)
In the Control Panel menu, set Roll DryingT ime to
at least 1 min.
( → P .49)
Y ou are using a paper that does not dry easily .
When paper that does not dry easily is used for
printing, it may curl during printing and touch the
Output T ray .
In this case, in the Control Panel menu, set Scan
W ait T ime to an option other than Off .
However , note that printing will now take longer .
( → P .49)
The back side of the paper is dirty
Cause Corrective Action
The Platen has become dirty after borderless printing
or printing on small paper .
Open the T op Cover and clean the Platen .
( → P .647)
Set W idth Detection to On in the Control Panel
menu, and then open the T op Cover and clean the
Platen .
( → P .647)
The Platen has become soiled because you have set
W idth Detection to Off in the Control Panel menu.
Open the T op Cover and clean the Platen . After this,
manually advance the roll onto the Platen before
printing.
( → P .647)
( → P .125)
The Paper Retainer is soiled. Clean the Paper Retainer .
( → P .647)
672 T roubleshooting