User manual

HP-GL/2 problems
HP-GL/2 jobs are printed 6 mm larger than specied
Cause Corrective Action
The page size of the HP-GL/2 print job, as created in
the source application, is incorrect.
In the Control Panel menu, set PageSizeProcess1
to On .
( → P .49)
HP-GL/2 jobs are printed at maximum size, even if a
standard size is specied
Cause Corrective Action
The page size of the HP-GL/2 print job, as created in
the source application, is incorrect.
In the Control Panel menu, set PageSizeProcess2
or Conserve Paper to On .
The layout will be changed to the optimal layout.
( → P .49)
HP-GL/2 printing takes a long time
Cause Corrective Action
Large print jobs with a lot of data take longer to print. Please wait a while until printing is nished.
A job was printed when Input Resolution in the
Control Panel menu was set to 600dpi .
In the Control Panel menu, set Input Resolution to
300dpi and print again.
( → P .49)
Replotting with HP-GL/2 jobs is not possible.
Cause Corrective Action
The data was lost because of replotting. Data for replotting is lost after the following
operations. In this case, send the print job again.
• The memory buf fer was cleared from the Control
Panel .
• The printer was turned of f.
• The printer has received a new HP-GL/2 print job.
• Printing has been canceled
The printer stops when printing a HP-GL/2 job (the
carriage stops moving)
Cause Corrective Action
The printer is analyzing the print job. Please wait a while until printing is nished.
A job was printed when Input Resolution in the
Control Panel menu was set to 600dpi .
In the Control Panel menu, set Input Resolution to
300dpi and print again.
( → P .49)
T roubleshooting 683