User manual

Messages regarding paper
Paper size not detected.
Cause Corrective Action
Follow these steps to reload the roll.
1. Push the Release Lever back.
2. Adjust the right edge of the roll to make it parallel
to the orange Paper Alignment Line .
3. Pull the Release Lever forward.
4. If Not nished printing. Finish printing
remaining jobs? is shown on the Display Screen ,
press the OK button.
Printing will resume, starting from the page on
which the error occurred.
( → P .106)
If this error recurs after you reload the roll, remove
the Roll Holder from the printer , push the roll rmly in
until it touches the Roll Holder ange, and reload the
Roll Holder in the printer .
( → P .103)
Paper has been loaded askew , or warped paper has
been loaded.
Follow these step to reload a sheet.
1. Push the Release Lever back.
2. Load the sheet, aligning it with the guide on the
right.
3. Pull the Release Lever forward.
4. If Not nished printing. Finish printing
remaining jobs? is shown on the Display Screen ,
press the OK button.
Printing will resume, starting from the page on
which the error occurred.
( → P .136)
Because the Platen is soiled with ink or other
substances, the size of the clear lm cannot be
detected.
Open the T op Cover and clean the entire Platen .
( → P .647)
Error Message 693