User manual

Messages regarding paper
Rel lever is in wrong position.
Cause Corrective Action
The Release Lever is pushed back. Pull the Release Lever forward.
T urn of f the printer and wait a while before restoring
power .
Borderless printng not possible.
Cause Corrective Action
Follow these steps to change the settings of the print
job to enable borderless printing.
1. Press ▲ or ▼ to select Stop Printing , and then
press the OK button.
2. Make sure the correct printer driver for the printer
is selected and try printing again.
For information on types of paper compatible with
borderless printing, refer to the Paper Reference
Guide .
( → P .95)
Select None when you have set Detect Mismatch
on the control panel to W arning .
The print job received species a type or width of
paper that is not compatible with borderless printing.
Press ▲ or ▼ to select Print W ith Border , and
then press the OK button to continue printing. The
document will be printed with a border .
Press ▲ or ▼ to select Stop Printing , and then
press the OK button.
Replace the paper with paper compatible for
borderless printing as follows.
1. Press ▲ or ▼ to select Change Paper , and then
press the OK button.
( → P .1 16)
( → P .1 18)
2. Replace the paper with paper compatible for
borderless printing.
( → P .103)
( → P .106)
The printer now starts printing the print job.
For information on types of paper compatible with
borderless printing, refer to the Paper Reference
Guide .
( → P .95)
The loaded paper is a size not compatible with
borderless printing.
Press ▲ or ▼ to select Print W ith Border , and
then press the OK button to continue printing. The
document will be printed with a border .
Error Message 701