User's Manual

3
With the edge of the roll paper facing forward as shown, in-
sert the Roll Holder from the right of the roll. Insert it firmly
until the roll touches the flange (a) of the Roll Holder, leav-
ing no gap.
4
Insert the Holder Stopper from the left in the Roll Holder as
shown. Holding it at the position shown (b), push it firmly in
until the flange (a) of the Holder Stopper touches the roll.
Lock the Holder Stopper lever (c) by pushing it down to-
ward the shaft side.
Loading Rolls in the Printer
Loading Rolls in the Printer
Follow these steps to load rolls in the printer.
Note
•
Before loading rolls, make sure the printer is clean inside the Top Cover and around the Ejection Guide. If these
areas are dirty, we recommend cleaning them in advance. (See "Cleaning Inside the Top Cover.") ➔P.514
1
Press the Load button.
2 Press ▲ or ▼ to select "Load Roll Paper", and then press the OK button.
Note
•
If any paper has been advanced that will not be used, a message is shown requesting you to remove it.
Press ▲ or ▼ to select Yes, and then press the OK button. Remove the paper and go to the next step.
a
c
b
a
Loading Rolls in the Printer iPF770
User's Guide
Handling and Use of Paper Handling rolls
322