User's Manual

Other Maintenance
17. Grasp the Belt , insert it between the Belt Stopper , and af x the Belt Stopper with a hex screw at
the position indicated.
Important
• Here, the Belt Stopper is the one that was removed and stored after initial installation. Neglecting to
attach the Belt Stopper may damage the printer .
• Do not touch the Linear Scale (a), Carriage Shaft (b), or Ink T ube Stabilizer (c). T ouching these
parts may damage them.
18. Close the T op Cover .
19. T ape down printer covers to secure them, in the reverse order of tape removal during installation.
20. If the Stationary Output Stacker is installed, reverse the installation procedure to remove the
Stationary Output Stacker .
21. Remove the Stand by reversing the installation procedure, when it was attached to the printer .
22. Disassemble and repackage the Stand by following the installation procedure in reverse.
23. Repack the Roll Holder , Holder Stopper , and printer in shipping materials, and then package
them in a shipping box.
614 Maintenance