User's Manual
Messages regarding paper
Paper cutting failed.
Cause Corrective Action
There are sheets left on the Ejection Guide .
1. Lift the Release Lever and remove the paper .
2. If Not nished printing. Finish printing
remaining jobs? is shown on the Display Screen ,
press the OK button.
Printing will resume, starting from the page on
which the error occurred.
There is a foreign object by the Output T ray ,
obstructing the Cutter Unit .
1. Lift the T op Cover and remove the foreign object.
2. If Not nished printing. Finish printing
remaining jobs? is shown on the Display Screen ,
press the OK button.
Printing will resume, starting from the page on
which the error occurred.
Y ou are not using the printer under the recommended
environmental conditions for the paper .
Use the printer only where the recommended
environmental conditions for the paper are met.
Note that various environmental conditions are
recommended for various types of paper . For details
on the recommended environmental conditions for
paper , see the Paper Reference Guide .
( → P .125)
Y ou are using paper that is not compatible with
automatic cutting.
Specify Manual as the cutting method and cut the
roll manually .
( → P .155)
For information about paper that is compatible with
automatic cutting, see the Paper Reference Guide .
( → P .125)
The Cutter Unit stops in the middle of cutting. If the Carriage is out, move the Carriage out of the
way , away from the paper .
If the Cutter is out, move the Cutter to the right side
(away from the paper) and remove the jammed paper .
( → P .147)
If the paper cannot be cut using the Cutter Unit ,
specify Manual as the roll cutting method and cut
the roll manually .
( → P .155)
In other cases, the Cutter Unit may be damaged. Contact your Canon dealer for assistance.
End of paper feed.
Cause Corrective Action
Y ou are pressing the ▲ button on the Control Panel
and trying to rewind the roll to the edge.
Release the ▲ button.
Paper can be retracted only up to 17 mm (0.7 in)
when using the Media T ake-up Unit .
Release the ▲ button.
668 Error Message