User's Manual
Control Panel
System Setup
Setting Item Description, Instructions
Buzzer Set the buzzer . Choose On for the buzzer to sound once for
warnings and three times for errors.
Detect Mismatch Choose W arning for notication (display of a warning message)
during printing if the type of paper specied in the printer menu
does not match the type in the printer driver . Choose None to
continue to print without notication. Choose Pause to have
printing paused under these circumstances. In this case, you
can continue printing by pressing the Online button.
W arning
Skip T ake-Up Err Choose On to continue with printing even if an error occurs with
the Media T ake-up Unit . Choose Off to have the printer pause
before printing if a rewinding error occurs.
Keep Paper Size Choose On to use the paper size setting as the basis for printing
instead of other settings. The margin setting of the printer menu
will be used instead of the margin setting of the printer driver if
the latter is smaller , which may prevent text or images in the
margin from being printed.
Choose Off to use the printer driver settings instead. Even if the
margin setting of the printer driver is smaller than that of the
printer menu, text or images will not be cut of f. However , this
requires longer paper because the actual margin will be equal to
the margin setting of the printer driver plus the margin setting of
the printer menu.
Sht Selection 1 If sheet size detection is activated, choose whether ISO A3+
or 13"x19"(Super B) is applied when an intermediate size is
detected.
Paper Size Basis
Sht Selection 2 If sheet size detection is activated, choose whether ISO B1
or 28"x40" (ANSI F) is applied when an intermediate size is
detected.
Noz. Check Freq. Specify the timing for automatic checks of nozzle clogging.
Choose 1 page to check once per printed page. Choose 10
pages to check once per ten printed pages. Choose Automatic
to have the printer automatically adjust the timing for checks
based on the frequency of nozzle use.
CarriageScanWdth For specifying the carriage scan width during printing. Select
Automatic for movement equivalent to the width of paper
loaded. Selecting Fixed will reduce any soiling on the back of
the paper , although printing may take a little longer .
Printer Parts 67