iPF840 User's Guide Ver.1.00

7 Print the job.
When printing is finished, the printer will stop without cutting.
8
Holding the printed document to prevent it from dropping,
press the Cut button to cut the roll.
Manual (when using media that cannot be cut with the Cutter Unit )
Rewind paper by pressing
the OK button
Feed paper to the cut
position by pressing the
Feed button and cut
manually
PrintSelect Manual
Manual
Rose Wine
Rose Wine
㩷
Note
•
Once the following step has been performed, the procedure can be started from step 8 the next time.
• Printing the second and subsequent times
• Printing after replacing with the same type of paper
1
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to
select the Paper tab ( ).
Note
•
If the Tab Selection screen is not displayed, press the Menu button.
2 Press the OK button. The Paper Menu is displayed.
3 Press ▲ or ▼ to select Paper Details, and then press the OK button.
4 Press ▲ or ▼ to select the type of paper, and then press the OK button.
5 Press ▲ or ▼ to select Cutting Mode, and then press the OK button.
6 Press ▲ or ▼ to select Manual, and then press the OK button.
7 When "Perform the detection of paper leading edge?" is displayed, select Perform(recommend).
8 Print the job.
The printer stops advancing the paper after printing.
Specifying the Cutting Method for Rolls iPF840
User's Guide
Handling and Use of Paper Handling rolls
362