iPF840 User's Guide Ver.1.00

Menu Structure
Menu Structure
The menu structure is shown categorized by tab. The * on the right side of an item indicates the default value.
The printer menu is classified into regular menu items available when no print job is in progress and menu during
printing items only available while printing is in progress. see "Printer Menu Operations." ➔ P.435
Regular menu Menu during printing
Paper Menu
Not displayed
Ink Menu The same Ink Menu as normal is displayed.
Job Menu The same Job Menu as normal is displayed.
Set./Adj. Menu A limited Set./Adj. Menu containing the following items is displayed.
• Adj. Fine Feed(*1)
• Printer Info
*1:Only displayed in the menu during printing. Not displayed in the regular menu.
For instructions on menu operations, see "Menu Operations." ➔ P.436
For details on menu items, see "Menu Settings." ➔ P.445
Menus may change according to the optional products in use.
Paper Menu
The Paper Menu is not displayed during printing.
First Level Second Level Third Level Fourth Level Fifth Level
Load Paper Roll 1 (Upper) | Roll 2 (Lower) | Cut Sheet
Eject Paper Roll 1 (Upper) | Roll 2 (Lower) | Cut Sheet
Chg. Paper Type(*1) Roll 1 (Upper) (The paper type is displayed here.) (*1)
Roll 2 (Lower) (The paper type is displayed here.) (*1)
Cut Sheet (The paper type is displayed here.) (*1)
Chg. Paper Size Sheet Size(*4) (The size of paper is displayed here.) (*2)
CustomPaperSize (Set the length and width)
Roll1(Uppr)Lngth(*3) (Set the length)
Roll2(Lwr) Lngth(*3) (Set the length)
Roll 1 Wdth(Upr)(*4) (Set the width)
Roll 2 Wdth(Lwr)(*4) (Set the width)
ManageRemainRoll Off* | On
Paper Details (The paper type is dis-
played here.) (*1)
Head Height Automatic* | Highest | High | Standard | Low |
Lowest
Skew Check Lv. Standard* | Loose | Off
Cutting Mode(*6) Automatic | Eject | Manual
Cut Speed Fast | Standard | Slow
Trim Edge First Automatic | Off | On (Preset Len) | On(Input
Length) | Manual
CutDustReduct. Off | On
VacuumStrngth Automatic* | Strongest | Strong | Standard | Weak
| Weakest
Scan Wait Time Dry time Off* | 1 sec. | 3 sec. |
5 sec. | 7 sec. | 9 sec.
Area(*5) Entire area* | Leading
edge
Roll DryingTime Off | 30 sec. | 1 min. | 3 min. | 5 min. | 10 min. | 30
min. | 60 min.
NearEnd RollMrgn 3mm | 20mm
NearEnd Sht Mrgn 3mm | 20mm
BordlessOversize Standard* | Little
iPF840 Menu Structure
User's Guide
Control Panel Printer Menu
439