iPF840 User's Guide Ver.1.00

Setting Item Description, Instructions
Inter-
face
Setup
TCP/IP IPv6 DNS
Settings
Sec. DNS SrvAddr
Specify the DNS server address.
DNS Host Name Specify the DNS host name.
DNS Domain Name Specify the DNS domain name.
Ether-
net
Driver
Auto Detect Specify the communication method. To apply your
changes, choose Register Setting.
Choose On for automatic configuration of the LAN com-
munication protocol. Choose Off to use settings values of
Comm.Mode and Ethernet Type.
Comm.Mode Choose the LAN communication method.
Ethernet Type Choose the LAN transfer rate.
Spanning Tree Choose whether spanning-tree packets are supported
over the LAN.
MAC Address Indicates the MAC address.
Interface Print Print interface settings information.
Return Defaults Choose OK to restore Interface Setup settings to the de-
fault values.
System
Setup
Sleep Timer Specify the period before the printer enters sleep mode.
Shut Down Timer Sets the time until the printer turns off automatically. If no
operations are performed on the printer for the duration of
the time set in Shut Down Timer after entering Sleep
mode, the printer automatically turns off.
Buzzer Choose On for the buzzer to sound once for warnings and
three times for errors.
Contrast Adj. Adjust the Display Screen contrast level.
Date &
Time
Date Set the current date.
Time Set the current time. Available only if the Date setting is
specified.
Date Format Specify the date format.
Language Specify the language used on the Display Screen.
Time Zone Specify the time zone. Time zone options indicate a main
city in this time zone and the difference from Greenwich
Mean Time.
Length Unit Choose the display unit for length. Change the unit dis-
played for the remaining amount of roll paper, Tot.Print
Area, and so on.
Detect Mismatch Specify printing behavior if the type and size of paper
specified in the printer menu does not match the type and
size in the printer driver.
Choose Pause to have printing paused under these cir-
cumstances. Choose Warning to continue printing after
notification. Choose None to continue printing without no-
tification. Choose Hold Job to store jobs with mismatched
types and sizes of paper on the printer hard disk, in a print
queue awaiting processing. (See "Using the Printer Hard
Disk.") ➔P.513
Paper
Size Ba-
sis
Sht Selection 1 If sheet size detection is activated, choose whether ISO
A3+ or 13"x19"(Super B) is applied when a sheet of an
intermediate size is detected.
Sht Selection 2 If sheet size detection is activated, choose whether ISO
B1 or 28"x40" (ANSI F) is applied when a sheet of an in-
termediate size is detected.
iPF840 Menu Settings
User's Guide
Control Panel Printer Menu
453