iPF840 User's Guide Ver.1.00

Note
• A test pattern is printed in black when you choose A:High or in magenta if you choose B:Standard/Draft.
• To cancel printing the test pattern for adjustment, hold down the Stop button. When "Stop printing?" is
displayed, press ▲ or ▼ to select Yes, and then press the OK button.
8 Press ▲ or ▼ to enter the amount of discrepancy, and then press the OK button.
If the scale is shorter than the actual size, use a positive setting value. If it is longer, use a negative value.
The feed amount can be adjusted in 0.02% increments.
Adjusting the Vacuum Strength
Adjusting the Vacuum Strength
When printing on heavyweight paper or paper that curls or wrinkles easily, if the Printhead rubs against paper, ad-
justing the level of suction against paper on the Platen may improve results.
Important
•
Paper rubbing against or becoming caught on the Printhead may jam or result in printed documents that are
soiled.
1
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to
select the Paper tab ( ).
Note
•
If the Tab Selection screen is not displayed, press the Menu button.
2
Press the
OK button.
The Paper Menu is displayed.
3 Press ▲ or ▼ to select Paper Details, and then press the OK button.
4 Press ▲ or ▼ to select the type of paper, and then press the OK button.
Note
•
When VacuumStrngth is set to Automatic, the setting value selected for the previous print job is dis-
played (to the right of Automatic ) once you select the type of paper currently supplied.
Note that this is not displayed if any of the following is executed.
• Turning off the power
• Replacing paper
•
Entering sleep mode
5 Press ▲ or ▼ to select VacuumStrngth, and then press the OK button.
6 Press ▲ or ▼ to select the desired setting value, and then press the OK button.
Ready
Plain Paper
OK: Paper Menu


Plain Paper
Adjusting the Vacuum Strength iPF840
User's Guide
Adjustments for Better Print Quality Adjusting the feed amount
564