iPF840 User's Guide Ver.1.00

8
Lower the Release Lever and close the Top Cover.
9
In a crouching position, push the Roll Unit in.
10 Position the Wheeled Output Stacker by the printer. (See "Using the Wheeled Output Stacker.") ➔P.375
11 Turn the printer on. (See "Turning the Printer On and Off.") ➔ P.17
Roll paper cannot be inserted into the Paper Feed Slot
Roll paper cannot be inserted into the Paper Feed Slot
Cause Corrective Action
The roll paper is warped. Straighten out curls and reload the roll.
Paper is jammed by the paper feed slot. Remove the jammed paper.
(See "Clearing Jammed Roll Paper.") ➔P.605
(See "Clearing a Jammed Sheet.") ➔P.608
The paper source selection is incorrect. Press the Load button and select the paper source.
If paper cannot be advanced from Roll 2 (Lower),
the Roll Unit Cable is disconnected.
Connect the Roll Unit Cable firmly to the Roll Unit Power Supply Inlet and the
inlet on the roll unit.
Cannot load sheets
Cannot load sheets
Cause Corrective Action
The paper source selection is incorrect. Press the Load button and select the paper source.
Paper is not cut neatly
Paper is not cut neatly
Cause Corrective Action
The paper is bent or curled at the cut position. Straighten out any curling by the edges of the paper.
Paper rises by the ends of the cut position be-
fore it is cut.
Reload the paper correctly.
You are using paper that cannot be cut with the
Cutter Unit.
Specify Manual in Cutting Mode in the Control Panel menu and use scissors or
a cutting tool to cut the roll after printing.
(See "Specifying the Cutting Method for Rolls.") ➔P.360
Roll paper cannot be inserted into the Paper Feed Slot iPF840
User's Guide
Troubleshooting Problems Regarding Paper
612