imagePROGRAF PRO-6000S series (PDF) User Manual (Windows)

Note
• If you change the mode without cutting the roll paper with the printer's cutter, a screen
confirming whether or not the paper taken up has been cut appears after you tap ON. If
the paper has not been cut, select No and cut the paper that has been taken up first.
3.
Load roll paper on roll unit.
For details, see "
Loading the Lower Roll on the Roll Unit."
•
Using as take-up device
1.
Tap Roll unit use setting.
2.
Tap ON when message confirming roll unit's change to take-up mode appears.
3.
Tap to select paper cutting settings when using take-up mode.
Note
•
If you selected Do not cut, the roll paper will not be cut after printing regardless of the
Cutting mode setting (See "Specifying the Cutting Method for Rolls.") on the printer.
Select this option when you want to print multiple pages consecutively without cutting.
• If you selected Use the cutting mode setting, cutting for each page will be performed
according to the Cutting mode setting (See "Specifying the Cutting Method for Rolls.") on
the printer.
• If you select Use the cutting mode setting, and Automatic Cutting is set in the Cutting
mode settings (See "Specifying the Cutting Method for Rolls.")on the printer, we
recommend setting Wind up after cutting to Enable. When set to Disable, a printed
document that has been taken up is cut automatically without being pressed, resulting in
fraying.
• If roll paper is loaded from the roll unit to the printer, a screen confirming whether or not to
remove the roll paper appears. If you select Yes, the roll paper is positioned so that it can
be removed and the roll unit changes to a take-up device.
4. Tap Yes or No when message confirming whether roll unit will be used immediately in take-up
mode appears.
If you tap Yes, the steps for loading the paper on the roll unit appear on the touch screen.
If you tap No, the operation ends here. Load the paper on the roll unit when printing. However,
in this case, you must load the paper while printing is progressing, so instructions will not
appear on the touch screen.
For details on loading paper on the roll unit set as a take-up device, see "
Using the Roll Unit In
Take-Up Mode."
Note
•
If you select Yes, a margin of approximately 23.62 inches (600 mm) is generated at the
leading edge because the roll paper advances to the roll unit before printing.
117