imagePROGRAF PRO-6000S series (PDF) User Manual (Windows)

1. Tap Yes.
The leading edge of the roll paper advances until it is close to the roll unit.
2.
Hold center of leading edge of roll paper, align right edge of take-up spool paper core's right
edge and tape center to paper core while pulling on roll paper evenly.
Outward Winding Inward Winding
Important
• If winding with inward winding, you must pass the leading edge of the roll paper to the
back of the paper core and secure with tape. If this operation is difficult, you can also
remove the roll holder, push the roll paper into the back, reinstall the roll holder, and pass
the roll paper to the back of the paper core.
3. Align right edge of roll paper to right edge of paper core while pulling on roll paper evenly, and
secure with tape.
4. While making sure that roll paper is flat, secure left edge of roll paper to paper core with tape.
Outward Winding Inward Winding
Important
•
Secure the left and right edges of the roll paper with tape within 1.97 inches (50 mm) of
the edges so that neither end of the roll paper lift up.
•
When rewinding heavyweight paper, use strong adhesive tape to fasten it. Otherwise, a
rewinding problem may result.
•
If you use a paper core narrower than the paper to be wound, adjust the position of the
holder stopper, so that there is a gap between the holder stopper and the paper.
122