imagePROGRAF PRO-6000S series (PDF) User Manual (Windows)

Setting Administrator Password on Operation Panel
You can specify or disable the administrator password.
Specifying the administrator password requires you to enter the password to use the items or change the
settings below.
• LAN settings
• Device user settings
• Language selection
• Auto maintenance settings
• Hard disk settings
• Administrator password setting
• Status print (administrator)
• Special administration mode
Follow the procedure below to specify the administrator password.
1.
Make sure printer is turned on.
2.
Flick HOME screen and tap Device settings.
Menu Operations
The Device settings screen appears.
3.
Tap Administrator password setting.
4.
When confirmation screen to specify administrator password is displayed, tap Yes.
If an administrator password is not specified, the register confirmation message appears. Tapping Yes
displays the message again. Tap OK.
Important
• The administrator password is set at the time of purchase. The printer's serial number is used as
the password.
For the administrator password, refer to Administrator Password.
5. Tap Change administrator password.
If you do not specify an administrator password, tap Remove administrator password. Tapping Yes
displays the message again. Tap OK.
6. Tap range where administrator password is valid.
Remote UI or other tools
Entering the administrator password is required to change the setting items using Remote UI or
some software.
180