Owner's Manual

MetaConsole for Unicenter NSM: Getting Started for Canon Guide 11
b. Click the Start Installer button.
The platform is detected and the platform-specific installer is saved locally
and executed.
3. Accept the license agreement.
You cannot install and use MetaConsole if you do not accept the agreement.
4. Select the component or components to install:
a. MetaConsole server
b. Client for CA Unicenter
5. Specify an installation directory.
The default directory is recommended.
On Windows, this is
C:\Program Files\MetaConsole.
On HP-UX, Linux, and Solaris, this is
/opt/MetaConsole.
6. [MetaConsole server] Specify a TCP/IP port number.
The default port number, 80, is recommended, but if it is already in use, you can
specify any unused port number.
7. [Windows NT, 2000, and XP] [MetaConsole server] Indicate whether MetaConsole
is to run as a Windows NT service.
8. [Windows NT, 2000, and XP] [MetaConsole server] If you chose, in step 7, to run
MetaConsole as a service, indicate whether it is to be started automatically at system
startup or manually as needed.
9. [client for Unicenter WorldView] Enter the name/address of the MetaConsole server
host that the client for Unicenter will use. Optionally, specify a port number by
following the name or address with a colon and the number.
(Example:
ServerMachineName:8080
)
10. [Windows] [client for Unicenter WorldView] Select the drive where Unicenter TND
is installed, and click OK.
11. [client for Unicenter WorldView] Enter the data repository name to be used.
12. [client for Unicenter WorldView] Indicate whether the Unicenter service is to be
started automatically or manually by selecting Manual or Automatic.
13. Review the summary of installation options, and click Install to begin the
installation.
14. Click Done to exit the installation program.