Owner's Manual

MetaConsole for Unicenter NSM: Getting Started for Canon Guide 18
3. Specify primary recipients by doing one or both of the following:
• To add a recipient to the To: List: In the To: Email Address box, type an email
address; then click the adjacent Add button.
• To remove an address from the To: List: Click the address; then click the
adjacent Remove button.
4. Specify “carbon copy” recipients by doing one or both of the following:
• To add a recipient to the Cc: List: In the Cc: Email Address box, type an email
address; then click the adjacent Add button.
• To remove an address from the Cc: List: Click the address; then click the
adjacent Remove button.
5. Specify “blind carbon copy” recipients by doing one or both of the following:
• To add a recipient to the Bcc: List: In the Bcc: Email Address box, type an
email address; then click the adjacent Add button.
• To remove an address from the Bcc: List: Click the address; then click the
adjacent Remove button.
6. In the From box, type the email address to be displayed as the sender of alarm email
messages.
Typically, this is a network administrator’s email address.
7. In the Subject box, type text to be included in alarm email messages as the subject.
Typically, this text indicates the purpose of the message (for example, “Device
Alert!”).
8. In the Relay Server box, type the name or IP address of the local network’s email
(SMTP) server computer.
Note: Alarm notification email cannot be delivered if this information is missing or
incorrect.
9. To send a test email message to the recipients specified in steps 3, 4, and 5, select the
Test Email on Apply check box.
10. Click Apply.
To specify settings for pager notification:
1. In the navigation pane, expand the top-level Configuration node and click Alarm
Notification Method.
2. Click the Settings… button next to the Pager check box.
Email notification settings appear at the bottom of the details pane.
3. Specify primary recipients by doing one or both of the following:
• To add a recipient to the Pager List:
a. In the Pager ID box, type a pager ID (typically a 10- or 11-digit phone
number).
b. In the Pager Service list, click the name of the paging service to be used.