Manualshelf

Owner's Manual

ManualsBrandsCanon ManualsB/W imageRUNNER CopiersCanon imageRUNNER 1310
10111213141516171819
MetaConsole Client for Canon Devices 10
Managing AppleTalk Properties
To display and change AppleTalk-related properties for a device:
1. In the navigation pane, expand the device’s node and the Networking node, and click
AppleTalk.
In the details pane, the following information is displayed:
Name The name of the print application.
Zone The zone of the print application.
Address The AppleTalk address in the format NNNN:OO:SS
NNNN is the network number, OO is the node number,
and SS is the socket number. For example: ff00:de:81
2. To change the phase type: In the Phase Type list, click a phase type, and then click
Apply.
Managing TCP/IP Properties
The TCP/IP properties that are displayed can differ depending on the device model.
To display and change TCP/IP-related properties for a device:
1. In the navigation pane, expand the device’s node and the Networking node, and click
TCP/IP.
2. In the details pane, change the following settings as desired:
TCP Settings
Enable TCP/IP Select this check box to enable TCP/IP, or clear it to
disable TCP/IP. (This check box might not be displayed.)
Frame Type The frame type is displayed here, but you cannot modify
it.
Configuration Click in the list to select a configuration method for IP
address information.
IP Address Type the IP address of the printer controller.
Subnet Mask Type the subnet address mask of the printer controller.
Gateway Address Type the gateway address of the printer controller.
DHCP Server Address (Only if your Configuration selection is DHCP) Type the
IP address of the DHCP server.
Enable DHCP (Only if your Configuration selection is DHCP) Select
this check box to enable DHCP, or clear it to disable
DHCP.
RARP Server Address (Only if your Configuration selection is RARP) Type the
IP address of the RARP server.
BOOTP Server Address (Only if your Configuration selection is BOOTP) Type
the IP address of the BOOTP server.
Enable BOOTP (Only if your Configuration selection is BOOTP) Select
this check box to enable BOOTP, or clear it to disable
BOOTP.