Operation Guide

124
Staple Finisher-G1/Booklet Finisher-G1 (Optional)
Check the location of the paper jam, and follow the procedure described below, while referring to the directions that appear on
the touch panel display, to remove the jammed paper.
The Staple Finisher-G1, Booklet Finisher-G1, and Bu er Pass Unit-H1 are optional products.
Inside the Top Cover
1
Remove any jammed paper protruding from the output part.
1
2
1. Lift the area indicated by
the label on the output
slot.
2. Remove any jammed
paper that is visible.
If you cannot see any paper,
check whether there is any
jammed paper in the output
area.
If a paper jam occurs when you are printing in the Staple mode, do not remove the output sheets that are
waiting to be stapled. (Printing and stapling resume after you clear the paper jam.)
2
Open the top cover of the  nisher, and remove any jammed paper.
1
1
2
2
3
3
*2*1
*1 Booklet Finisher-G1
*2 Staple Finisher-G1
1. Open the top cover of the  nisher.
2. Remove any jammed paper.
3. Close the top cover of the  nisher.
When closing the cover, be careful not to get your  ngers caught, as this may result in personal
injury.