Operation Guide

155
Troubleshooting
Setting the Limited Functions Mode from the Service Call
Message Screen
When [Limited Functions Mode] is displayed, follow the procedures below.
If you turn OFF the main power switch when there is a job waiting to print, that job is erased.
If you set Limited Functions Mode to ‘On’ from the Service Call Message screen, [Limited Functions Mode] in [Management
Settings] (Settings/Registration) is also set to ‘On’. (See e-Manual > Security.)
1
Press [Limited Functions Mode]  [Yes].
A message prompting you to restart the machine (turning the main power switch OFF, and then
ON) appears.
2
Turn OFF the main power of the main unit.
1
2
3
1. Open the main power switch
cover.
2. Press the main power switch
to the “
” side.
3. Close the main power switch
cover.
3
Wait at least 10 seconds after the Main Power Indicator is turned o , and then
turn the main power switch back to ON.
2
1
3
1. Open the main power switch
cover.
2. Press the main power switch
to the “I” side.
3. Close the main power switch
cover.
The machine starts up in the Limited Functions mode.