User manual

Handling sheets
If the optional Roll Feed Unit is installed
1. If you send a print job specifying a paper other than POP Board from a computer beforehand,
the type and size of paper are shown on the Display Screen .
Note
• If you will load paper before sending a print job, press the Feeder Selection button to illuminate the
Paper T ray lamp . A screen is shown on the Display Screen for selection of the paper type. Press
◄ or ► to select the type of paper , and then press the OK button. Next, a menu for selection of
the paper size is shown on the Display Screen . Press ◄ or ► to select the size of paper , and
then press the OK button.
• For details on paper types, see the Paper Reference Guide . ( → P .103) By factory default, Plain
Paper is selected.
• If this setting does not match the loaded paper , it may cause feed errors and af fect the printing quality .
2. Open the Paper T ray Cover .
3. Slide the Width Guide (a) to align it with the mark for the size of paper you will load.
4. Load the paper in the T ray with the printing side face-up.
Insert the paper until its edge touches the far end of the tray lightly .
Caution
• If you load A2 or larger in the printer , the paper goes down on the back of the printer under its own
weight. Therefore, place your hands on the paper till the paper is fed.
Handling Paper 159