User manual

Handling rolls

Selecting the Paper Source

When advancing paper , press the Feeder Selection button and select the source.

Y ou can determine the selected source by checking which lamp is lit-either the Roll Media lamp (a) or the

Cut Sheet lamp (b).

• Roll Media lamp : Selected when printing on Roll Media .

• Cut Sheet lamp : Selected when printing on Sheets from the T op Paper Feed Slot or Front Paper

Feed Slot .

Note

• If any paper is loaded that will not be used, a message is shown on the Display Screen (either Remove

roll? or Eject sheet? ) when you press the Feeder Selection button.

T o remove the paper , press the OK button. ( → P .142)

• Y ou cannot switch the paper source in the following situations:

• When the Message lamp is ashing

Check the message on the Display Screen and take action as necessary . ( → P .681)

• When the Data lamp is ashing

Select the paper source after printing is nished.

• When a printer menu operation is in progress

W ait until the operation is nished before selecting the paper source.

• When in the process of loading paper

Finish loading the paper before selecting the paper source.

• When in the process of replacing ink tanks

Finish replacing the Ink T ank before selecting the paper source.

• When the T op Cover is open

Close the T op Cover before selecting the paper source.

1 12 Handling Paper