UFRII LT PRINTER KIT-J2 Installation Procedure Follow the instructions herein when installing the UFRII LT PRIJNTER KIT-J2 to its host machine. PUB No.
1.1 Checking components 1.1.1 Checking the Contents [1] [2] [3] [7] [6] [5] [4] [9] [8] F-1-1 [1] LAN cover 1 pc. [6] User Software CD-ROM 1 pc. [2] LAN PCB 1 pc. [7] User Manual CD-ROM 1 pc. [3] IP-LAN cable 1 pc. [8] Release Note 1 pc. [4] Wire saddle 1 pc. [9] Network Quick Start Guide 1 pc. [5] TP screw (3x8) 8 pc.
1.2 Installation procedure [2] 1.2.1 Mounting to the iR Machine 1) Turn off the main power switch, and disconnect the power plug from the power outlet. 2) Remove the machine’s rear cover [1]. - 4 screws [2] [1] [2] F-1-4 5) Connect the LAN board and the IP board. - 1 IP-LAN cable [1] [2] [1] [1] F-1-2 3) Cut off the area [2] of the rear cover [1] indicated F-1-5 in the figure using nippers. 6) Fit the wire saddle (black) [1] in place, and fit the [1] IP-LAN cable [2] in it.
9) Connect the user's LAN cable to the machine. 7) Mount the LAN cover [1]. - 4 TP screws (3x8) [2] [2] F-1-9 [1] [2] 10) Connect the power plug to the power outlet, and F-1-7 turn on the main power switch. 1.2.2 Checking the Connection When mounting the LAN cover [1], take care so that the grounding plate [3] will not be bent by the LAN At the end of the work, go through the following steps board [2].