Installation Procedure Memory iR 256MB Expansion RAM-D1 Sep 14 2005
Application This manual has been issued by Canon Inc. for qualified persons to learn technical theory, installation, maintenance, and repair of products. This manual covers all localities where the products are sold. For this reason, there may be information in this manual that does not apply to your locality. Corrections This manual may contain technical inaccuracies or typographical errors due to improvements or changes in products.
Introduction Symbols Used This documentation uses the following symbols to indicate special information: Symbol Description Indicates an item of a non-specific nature, possibly classified as Note, Caution, or Warning. Indicates an item requiring care to avoid electric shocks. Indicates an item requiring care to avoid combustion (fire). Indicates an item prohibiting disassembly to avoid electric shocks or problems. Indicates an item requiring disconnection of the power plug from the electric outlet.
Introduction The following rules apply throughout this Service Manual: 1. Each chapter contains sections explaining the purpose of specific functions and the relationship between electrical and mechanical systems with reference to the timing of operation. In the diagrams, represents the path of mechanical drive; where a signal name accom- panies the symbol , the arrow indicates the direction of the electric signal.
Contents Contents Chapter 1 Installation Procedure 1.1 Unpacking and Checking the Components .................................................................................................... 2 1.1.1Checking the Contents................................................................................................................................. 2 1.2 Installation Procedure ..................................................................................................................................
Contents
Chapter 1 Installation Procedure
Chapter 1 1.1 Unpacking and Checking the Components 1.1.1 Checking the Contents 0011-0743 F-1-1 T-1-1 [1] 2 256MB RAM 1 pc.
Chapter 1 1.2 Installation Procedure 1.2.1 Mounting to the Host Machine 0010-9409 1) Turn off the main power switch, and disconnect the power plug. 2) Remove the rear cover [1]. [1] - 4 screws [2] F-1-3 4) Remove the RAM cover [1]. - 4 screws [2] [2] [2] [1] F-1-2 [1] F-1-4 3) If a Super G3 Fax Board-T1 is found, disconnect the connector [1] of the IP-modem cable. 5) Remove the 128MB RAM [1] in the direction of [A].
Chapter 1 3) Press [ ] once. When [REPORT OUTPUT] has appeared, press [OK]. 4) Press [ ] 5 times. When [SPEC LIST] has ap- peared, press [OK]. 5) 'SPEC REPORT' is printed out. Check if 'TOTAL MEMORY' is described as '256MB' on the report. [1] F-1-6 7) Mount 256MB RAM [1]. [1] F-1-7 8) Put back the parts that have been removed. - RAM cover - the connector of the IP-modem cable (if a Super G3 Fax Board-T1 is mounted) - rear cover 9) Connect the power plug, and turn on the main power switch. 1.2.
Sep 14 2005
