PCL PRINTER KIT-J1 Installation Procedure Follow the instructions herein when installing the PCL PRINTER KIT-J1 to its host machine. PUB No.
1.1 Checking components 1.1.1 Checking the Contents [2] [1] [4] [3] [6] [5] F-1-1 [1] 32MB ROM 1 pc. [2] 256MB RAM 1 pc. [3] Screw (binding; M3x4) 1 pc. [4] User software CD-ROM 1 pc. [5] Release Note 1 pc. [6] User's Manual CD-ROM 1 pc.
1.2 Installation procedure 4) If a Super G3 Fax Board-T1 is found, disconnect the connector [1] of the IP-modem cable. 1.2.1 Mounting to the Host Machine If an optional Super G3 Fax Board-T1 is found, the SDRAM and the super capacitor remain powered to 1) Turn off the main power switch, and disconnect the back up the image memory (even after the main power power plug. switch has been turned off and the power plug has 2) Remove the rear cover [1]. been disconnected).
6) Remove the 128MB RAM [1] in the direction of [2] [1] [A]. - 2 locking levers [2] (shift in the direction of [B]) [B] [A] [3] [B] [2] F-1-8 [1] F-1-6 8) Disconnect the soft ID cable [1]. - 1 cable clamp [2] 7) If a UFRII LT PRINTER KIT-J2 is installed, perform steps 7-1) and 7-2). 7-1) Remove the LAN cover [1]. - 4 screws [2] [2] [2] [1] F-1-9 9) Release the claw [1] of the cable guide, and free the cable guide [2] in upward direction.
12) Connect the connector [1] of the 32MB ROM to 10) Remove the IP cover [1]. the connector [2] of the IP PCB. - 10 screws [2] - 1 screw (binding; M3x4) [3] [2] [2] [2] [1] [3] F-1-13 [1] [2] 13) Attach the IP cover you removed in step 10). F-1-11 11) Shift the 2 locking levers [1] back to their initial position. When attaching the IP cover, take care not to damage the grounding plate [2] by the USB port [1].
14) Put all the parts that you have removed back in 16) Mount the 256MB RAM [1]. place. - cable guide - soft ID cable - IP-LAN cable (if a UFRII LT PRINTER KIT-J2 is mounted) 15) Attach the LAN cover removed in step 7-1). (if a UFRII LT PRINTER KIT-J2 is mounted) [1] When attaching the LAN cover, take care not to F-1-16 damage the grounding plate [2] by the LAN port [1]. Also, after attaching the LAN cover, check to make 17) Put back the parts that have been removed.