Service manual

Chapter 4
4-22
F-4-78
4.4.5.6 Removing the Copyboard Cover Open/Close
Sensor (Front/Rear)
0010-4310
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Disconnect the to connectors [1], and then remove the screw [2].
2) Remove the reusable band [3], and then remove the harness [4] from the
sensor mount.
3) Remove the sensor mount [5].
4) Remove the sensor from the sensor mount.
F-4-79
4.4.6 Contact Sensor HP Sensor
4.4.6.1 Removing the Copyboard glass
0010-6113
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Open the copyboard cover (or ADF).
2) Remove the two screws [1], remove the glass retainer [2], and then
remove the copyboard glass [3].
F-4-80
When removing the copyboard glass, take care not to touch the
following:
- Glass surface
- Standard white plate
Dirt on these parts can show up as white/black lines in the image. If dirt is
found, remove it with lint-free paper moistened with alcohol.
F-4-81
F-4-82
4.4.6.2 Removing the ADF Reading Glass
0010-6114
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Open the copyboard cover (or ADF).
2) Remove the two screws [1], and then remove the glass retainer [2].
3) Remove the ADF reading glass [3].
F-4-83
- When removing the ADF reading glass, take care not to touch the glass
surface. Dirt on these parts can show up as white/black lines in the image.
If dirt is found, remove it with lint-free paper moistened with alcohol.
- When installing the ADF reading glass, position the cut portion [1] of the
ADF reading glass sheet at the front-left corner.
[1]
[2]
[1][5]
[2]
[3]
[4]
[1]
[2]
[3]
[3]
[1]
[2]