Service manual

Chapter 4
4-25
F-4-96
When removing the copyboard glass, take care not to touch the
following:
- Glass surface
- Standard white plate
Dirt on these parts can show up as white/black lines in the image. If dirt is
found, remove it with lint-free paper moistened with alcohol.
F-4-97
F-4-98
4.4.8.2 Removing the Reader Heater (Right)
0010-4319
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the screw [1], and then detach the heater cover [2].
F-4-99
2) Remove the screw [1].
3) Disconnect the connector [2], disconnect the harness from the wire saddle
[3], and then remove the reader heater (right) [4].
F-4-100
4.4.8.3 Removing the Reader Front Cover
0010-6118
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Open the copyboard cover (or ADF).
2) Remove the two screws [1], and then detach the reader front cover [2].
F-4-101
4.4.8.4 Removing the ADF Reading Glass
0010-6120
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Open the copyboard cover (or ADF).
2) Remove the two screws [1], and then remove the glass retainer [2].
3) Remove the ADF reading glass [3].
[1]
[2]
[3]
[1][2]
[3] [1][2][4]
[1]
[2]