Service manual

Chapter 6
6-9
6.10 Parts Replacement Procedure
6.10.1 Drum Unit
6.10.1.1 Removing the Drum Unit
0010-6179
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Open the front cover [1].
2) Turn the developing assembly locking lever [2] clockwise to open the left
door [3].
3) Draw out the drum unit [4].
F-6-16
- When attaching or detaching the drum unit, open the left door fully to pre-
vent the damage to the drum unit.
- To prevent exposure of the drum, cover the drum unit with a few sheets of
paper and place it in a safe place.
6.10.2 Developing Assembly
6.10.2.1 Removing the Drum Unit
0010-6181
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Open the front cover [1].
2) Turn the developing assembly locking lever [2] clockwise to open the left
door [3].
3) Draw out the drum unit [4].
F-6-17
- When attaching or detaching the drum unit, open the left door fully to pre-
vent the damage to the drum unit.
- To prevent exposure of the drum, cover the drum unit with a few sheets of
paper and place it in a safe place.
6.10.2.2 Removing the Rear Cover
0010-6182
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the four screws [1], and then detach the rear cover [2].
F-6-18
6.10.2.3 Removing the Right Cover (Lower)
0010-6183
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Open the front cover.
2) Remove the five screws [1]. Remove the two hooks [2], and then detach
the right cover (lower) [3].
F-6-19
6.10.2.4 Removing the Delivery Tray
0010-6184
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the two screws [1], and then detach the delivery tray [2].
F-6-20
6.10.2.5 Removing the Developing Assembly
0010-6185
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the screw [1], and remove the developing assembly locking lever
[2].
2) Release the two hooks [3] (marked with ), and then remove the toner
bottle cover [4].
[2]
[1]
[3]
[4]
[2]
[1]
[3]
[4]
[1]
[2]
[1]
[2]
[3]
[1]
[1] [2]