Service manual

Chapter 6
6-10
F-6-21
3) Draw out the developing assembly [1].
F-6-22
6.10.2.6 Precautions about Installation of Developing
Assembly
0010-6186
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
When installing the developing assembly, follow the precaution given
below.
Front side
Fit the convex portion of the main body in the concave portion on the bottom
of the developing assembly.
F-6-23
Rear side
Fit the pin [1] seen in the back of the main body in the support hole [2] pro-
vided at the back of the developing assembly.
F-6-24
6.10.2.7 Procedure after Replacing the Developing
Assembly
0011-2541
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
<Going through the Developer Idling Mode>
After replacing the developing assembly, go through the following steps
in the developing assembly idle rotation mode before installing the toner car-
tridge.
1) Plug the power cord into the outlet.
2) Open the front cover.
3) With the front cover open, turn on the main power switch.
4) When a message appears on the operation panel display, press the
following keys to enter the service mode:
Additional Functions key > 2 key > 8 key > Additional Functions key
5) Select "#PRINT" using the + or - key, and then press the OK key.
6) Select "#PRINT SW" using the + or - key, and hen press the OK key.
Confirm that the following message is displayed:
Message: #PRINT SW 001 00000000
7) Press the following keys and confirm the message:
# key > 1 key > 1 key
Message: #PRINT SW 011 00000000
8) Position the cursor to Bit-1 (second from right) using the + or - key, and
press the 1 key, and then confirm the following message:
Message: #PRINT SW 011 00000010
9) Press the OK key. Confirm that "SW 011" changes to "SW 012".
Message: #PRINT SW 012 00000000
10) Press the Reset key to exit the service mode.
11) Close the front cover. The machine will run in the developer idling mode
for about 1 minute.
12) When the machine stops, the idling mode ends.
Install, the toner cartridge following the above-mentioned procedure.
6.10.3 Transfer Charging Roller
6.10.3.1 Removing the Transfer Charging Roller
0010-6187
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Open the left door.
2) Remove the transfer charging roller [1]
F-6-25
Do not touch the transfer charging roller surface.
[1]
[2]
[3]
[4]
[1]
[1] [2]
[1]