Service manual

Chapter 7
7-13
F-7-34
7.5.8 Manual Feed Pickup Solenoid
7.5.8.1 Removing the Drum Unit
0011-2965
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Open the front cover [1].
2) Turn the developer pressure release lever [2] clockwise, and then open the
left door [3].
3) Draw out the drum unit [4].
F-7-35
To prevent exposure to light, cover the drum with several sheets of copy
paper and place it in a safe place.
Open the left door fully to prevent the damage to the drum unit
7.5.8.2 Removing the Transfer Registration Unit
0011-2966
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the four screws [1], and then remove the transfer registration unit
[2].
F-7-36
7.5.8.3 Removing the Feed Guide
0011-2967
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the two screws [1], and then remove the feed guide [2].
F-7-37
7.5.8.4 Removing the Multifeeder Connector Cover
0011-1051
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Detach the multifeeder connector cover [1], and then disconnect the three
connectors [2].
F-7-38
7.5.8.5 Removing the Multifeeder Unit
0011-1050
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the four screws [1], and then remove the multifeeder unit [2].
F-7-39
7.5.8.6 Removing the Multifeeder Pickup Solenoid
0011-1052
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Disconnect the connector [1], and then remove the harness from the guide.
2) Remove the screw [2], and then remove the multifeeder pickup solenoid
[3].
[1]
[2][3]
[2]
[1]
[3]
[4]
[1]
[1]
[2]
[1]
[2]
[1]
[2]
[1]
[2]