Service manual

Chapter 8
8-10
F-8-21
8.4.2.5 Removing the Fixing Unit
0010-9940
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the two screws [1], and then detach the inner cover [2] at the
upper front.
F-8-22
2) Remove the screw [1], and then detach the heater harness cover [2].
Disconnect the connector [3].
F-8-23
3) Disconnect the two connectors [1], and then release the fixing unit harness
from the wire saddle [2].
F-8-24
4) Raise the delivery upper guide [1]. Remove the three screws [2], and then
remove the fixing unit [3].
F-8-25
8.4.2.6 Removing the Fixing Film Unit
0010-9941
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Release the hooks [1], and then remove the spur unit [2] by sliding it.
F-8-26
2) Remove the resin ring [1], and then remove the fixing pressure release
lever [2].
F-8-27
[1]
[2]
[1]
[1]
[3]
[2]
[1]
[2]
[1]
[2] [3] [2]
[1]
[1]
[2]
[2]
[1]