Service manual

Chapter 8
8-13
F-8-43
When installing the pressure roller, bring the ground plate [4] into contact
with the roller shaft [5].
F-8-44
8.4.3 Fixing Film
8.4.3.1 Removing the Drum Unit
0010-9923
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Open the front cover [1].
2) Turn the developing assembly locking lever [2] clockwise to open the left
door [3].
3) Draw out the drum unit [4].
F-8-45
- When attaching or detaching the drum unit, open the left door fully to pre-
vent the damage to the drum unit.
- To prevent exposure of the drum, cover the drum unit with a few sheets of
paper and place it in a safe place.
8.4.3.2 Removing the rear cover
0010-9924
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the four screws [1], and then detach the rear cover [2].
F-8-46
8.4.3.3 Removing the Left Cover (Rear)
0010-9925
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the three screws [1], and then detach the left cover (rear).
F-8-47
8.4.3.4 Removing the Left Door
0010-9926
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the screw [1] securing the door support band. Remove the
connector [2] and reusable band [3], and release the duplex unit harness
from the wire saddle [4].
F-8-48
2) Open the left door until it sops and pull out the hinge shaft [1].
MEMO:
When a duplex unit (option) is installed, remove it before pulling out the
hinge shaft for each access.
[1][2]
[3]
[4] [5]
[2]
[1]
[3]
[4]
[1]
[2]
[1]
[2]
[1]
[1]
[2]
[3] [4]