Service manual

Chapter 8
8-19
F-8-82
2) Remove the fixing unit harness [2] from the wire saddle [1] and harness
guide.
F-8-83
3) Remove the screw [1], and then remove the fixing paper guide [2].
F-8-84
4) Remove the screw [1], and then remove the right side stay [2].
F-8-85
5) Remove the connector [1], and then remove the sensor harness [2].
Remove the screw [3], release the hook [4], and then remove the sensor
holder [5].
F-8-86
6) Release the four sensor claws [1], and then remove the fixing delivery
sensor [2].
F-8-87
When installing the sensor holder, place the electrode plate [1] under the
three claws.
F-8-88
8.4.5 Fixing Film Sensor
8.4.5.1 Removing the Drum Unit
0010-9913
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Open the front cover [1].
2) Turn the developing assembly locking lever [2] clockwise to open the left
door [3].
3) Draw out the drum unit [4].
F-8-89
- When attaching or detaching the drum unit, open the left door fully to pre-
vent the damage to the drum unit.
- To prevent exposure of the drum, cover the drum unit with a few sheets of
paper and place it in a safe place.
8.4.5.2 Removing the Rear Cover
0010-9918
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the four screws [1], and then detach the rear cover [2].
[1][2]
[1][2]
[1] [2]
[1]
[2]
[5]
[1]
[3]
[4]
[2]
[2] [1]
[1]
[2]
[1]
[2]
[1]
[3]
[4]