Service manual

Chapter 9
9-5
F-9-17
9.4.2 Fixing Drive Assembly
9.4.2.1 Removing the Drum Unit
0011-0607
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Open the front cover [1].
2) Turn the developing assembly locking lever [2] clockwise to open the left
door [3].
3) Draw out the drum unit [4].
F-9-18
- When attaching or detaching the drum unit, open the left door fully to pre-
vent the damage to the drum unit.
- To prevent exposure of the drum, cover the drum unit with a few sheets of
paper and place it in a safe place.
9.4.2.2 Removing the Rear Cover
0011-0608
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the four screws [1], and then detach the rear cover [2].
F-9-19
9.4.2.3 Removing the Left Cover (Rear)
0011-0610
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the three screws [1], and then detach the left cover (rear).
F-9-20
9.4.2.4 Removing the Left Door
0011-0611
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the screw [1] securing the door support band. Remove the
connector [2] and reusable band [3], and release the duplex unit harness
from the wire saddle [4].
F-9-21
2) Open the left door until it sops and pull out the hinge shaft [1].
MEMO:
When a duplex unit (option) is installed, remove it before pulling out the
hinge shaft for each access.
[2]
[1]
[3]
[4]
[1]
[2]
[1]
[2]
[1]
[1]
[2]
[3] [4]