Service manual

Chapter 9
9-13
F-9-66
9.4.7.5 Removing the HVT PCB
0010-9975
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the connector [1] and screw [2], and then remove the HVT PCB.
F-9-67
When installing the HVT PCB, check that the contacts on the high voltage
electrode plate [1] touch the contacts on the PCB.
F-9-68
9.4.8 Fixing Heat Discharge Fan
9.4.8.1 Removing the Fixing Heat Discharge Fan
0011-0419
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Open the left door until it stops.
2) Remove the four screws [1], and then remove the transfer/registration unit
[2].
F-9-69
3) Disconnect the connector [1], and then release the harness from the wire
saddle [2].
F-9-70
4) Remove the two screws [1], and then remove the duct [2].
F-9-71
5) Remove the fixing heart discharge fan [1].
[2]
[2]
[1][3]
[1]
[1] [1]
[2]
[2]
[1]
[2]
[1]