Service manual

Chapter 13
13-7
E542 0001 - Optional tray motor or finisher controller PCB failure
- Optional tray HP sensor failure
- Optional tray clock sensor failure
- Optional tray shift motor load failure
The optional tray was operated, but the
paper surface was not detected.
- Check the connector of the optional tray HP
sensor.
- Check the connector of the optional tray clock
sensor.
- Check the connector of the optional tray shift
motor.
- Replace the optional tray HP sensor.
- Replace the optional tray clock sensor.
- Replace the optional tray shift motor.
- Replace the finisher controller PCB.
0002 - Optional tray motor or finisher controller PCB failure
- Optional tray HP sensor failure
- Optional tray clock sensor failure
- Optional tray shift motor load failure
Cannot move (to the pickup position)
within the specified time.
- Check the connector of the optional tray HP
sensor.
- Check the connector of the optional tray clock
sensor.
- Check the connector of the optional tray shift
motor.
- Replace the optional tray HP sensor.
- Replace the optional tray clock sensor.
- Replace the optional tray shift motor.
- Replace the finisher controller PCB.
0003 - Optional tray motor or finisher controller PCB failure
- Optional tray HP sensor failure
- Optional tray clock sensor failure
- Optional tray shift motor load failure
- The optional tray was moved upward,
but it did not reach the HP sensor within
3000 ms.
- Check the connector of the optional tray HP
sensor.
- Check the connector of the optional tray clock
sensor.
- Check the connector of the optional tray shift
motor.
- Replace the optional tray HP sensor.
- Replace the optional tray clock sensor.
- Replace the optional tray shift motor.
- Replace the finisher controller PCB.
0005 - Optional tray motor or finisher controller PCB failure
- Optional tray HP sensor failure
- Optional tray clock sensor failure
- Optional tray shift motor load failure
- The encoder clock signal was not
detected two or more times when the
optional tray was operated for 300 ms.
- Check the connector of the optional tray HP
sensor.
- Check the connector of the optional tray clock
sensor.
- Check the connector of the optional tray shift
motor.
- Replace the optional tray HP sensor.
- Replace the optional tray clock sensor.
- Replace the optional tray shift motor.
- Replace the finisher controller PCB.
E575 0001 - Stack delivery motor or finisher controller PCB failure
- Stack delivery HP sensor failure
- The stack delivery motor was driven for
2000 ms in the stack delivery direction
(HP sensor approach direction), but the
stack delivery HP sensor did not turn on.
- Check the connector of the stack delivery HP
sensor.
- Check the connector of the stack delivery motor.
- Check the connector of the stack delivery HP
sensor.
- Replace the stack delivery motor.
- Replace the finisher controller PCB.
0002 - Stack delivery motor or finisher controller PCB failure
- Stack delivery HP sensor failure
- The stack delivery motor was driven for
2000 ms in the HP sensor escape
direction, but the stack delivery HP
sensor did not turn off.
- Check the connector of the stack delivery HP
sensor.
- Check the connector of the stack delivery motor.
- Check the connector of the stack delivery HP
sensor.
- Replace the stack delivery motor.
- Replace the finisher controller PCB.
Display
code
Detail
Code
Main Cause/Symptom Countermeasure