Service manual

Chapter 14
14-4
#SCAN
No. Initial setting Range setting Explanation
#SCAN SW SW1 00000000 Outputting an Image for ADF Squareness Adjsutment
SW2 - SW50 Not used
#SCAN
NUMERIC
001: - 023: Not used
024: 385 300 to 450, one
unit=0.1mm
CIS scan position during ADF scanning.
026: 22 6 to 48, one
unit=0.1mm
Distance from the standby position of CIS to the shading start point.
027: - 030: Not used
031: 35 0 to 70, one
unit=0.1mm
Vertical scan start position adjustment
032: 115 50 to 150, one
unit=0.1mm
Horizontal scan start position adjustment
033: 16 0 to 32, one
unit=0.1%
Vertical scan magnification correction
034: Not used
035: - 036: 474 Reader motor speed adjustment
037: - 040: Not used
041: 35 0 to 70, one
unit=0.1mm
Vertical scan start position adjustment (scanning on ADF)
042: 220 170 to 270, one
unit=0.1mm
Horizontal scan start position adjustment (scanning on ADF)
043: 24 0 to 200, one
unit=0.1mm
Horizontal scan end position correction (copy)
044: 36 0 to 200, one
unit=0.1mm
Horizontal scan end position correction (superfine)
045: 47 0 to 200, one
unit=0.1mm
Horizontal scan end position correction (fine)
046: 47 0 to 200, one
unit=0.1mm
Horizontal scan end position correction (standard)
047: 16 0 to 32, one
unit=0.1%
Vertical scan magnification correction (scanning on ADF)
048: 16 0 to 32, one
unit=0.1%
Horizontal scan magnification correction (scanning on ADF)
049: - 053: Not used
054: 16 0 to 32, one
unit=0.1%
Pickup motor speed correction (when the ADF is used)
055: - 192: Not used
193: 0 0: LEGAL
1: FOOLSCAP
2: M_OFFICIO
3: A_FOOLSCAP
4: FOLIO
5: G_LEGAL
6: A_OFFICIO
7: B_OFFICIO
ADF special paper, standardized size: LGL misidentification-ready
194: 0 0: LTR
1: G_LTR
2: A_LTR
ADF special paper, standardized size: LTR misidentification-ready
195: 0 0: LTR_R
1: FOOLSCAP
2: OFFICIO
3: E_OFFICIO
4: G_LTR_R
5: A_LTR_R
ADF special paper, standardized size: LTR_R misidentification-ready
196: 272 0 to 511 shading target value (red)
197: 272 0 to 511 shading target value (green)
198: 272 0 to 511 shading target value (blue)
199: - 350: Not used
#PRINT
No. Initial setting Range setting Explanation
#PRINT SW SW01 - SW04 Not used
SW05 10000000 Horizontal scanning priority record
SW06 - SW13 Not used
SW14 00000000 Special mode setting
SW15 00000000 Delivery setting
SW16 - SW50 Not used