Service manual

Chapter 2
2-4
F-2-10
6) Turn the developer pressure release lever [1] counterclockwise, and then
close the left door [2].
F-2-11
7) Enter the date in the drum counter label [1].
F-2-12
8) Affix the drum counter label [1] on the drum unit.
F-2-13
9) Close the front cover [1].
F-2-14
2.2.3 Installing the Toner Bottle
0011-1072
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
If the machine is installed in a low-temperature, low-humidity place, the im-
age density may be slightly lower than usual on the first approx. 100 sheets
printed after installation of the machine.
When installing the machine in a low-temperature, low-humidity environ-
ment, perform the steps mentioned in <Going through the Developer
Idling Mode> (provided after step 6 in this section) before installing the ton-
er bottle.
1) Shake the toner bottle 5-6 times.
F-2-15
2) Open the front cover [1].
F-2-16
3) Insert the toner bottle.
F-2-17
4) While holding the toner bottle, pull the seal [1] to remove it.
F-2-18
[1]
[1]
[2]
[1]
[1]
[1]
[1]
[1]