Service manual

Chapter 2
2-5
5) Turn the toner cartridge in the direction of the arrow until it stops.
F-2-19
6) Close the front cover.
F-2-20
<Going through the Developer Idling Mode>
When installing the machine in a low-temperature, low-humidity environ-
ment, go through the developer idling mode before installing the toner bottle
in order to prevent the density from becoming low on the first approx. 100
sheets.
1) Plug the power cord into the outlet.
2) Open the front cover.
3) With the front cover open, turn on the main power switch.
4) When a message appears on the control panel display, press the following
keys to enter the service mode:
Additional functions key > 2 key > 8 key > Additional functions key
5) Select "#PRINT" using the + or - key, and then press the OK key.
6) Select "#PRINT SW" using the + or - key, and then press the OK key.
Confirm that the following message is displayed:
Message: #PRINT SW 001 00000000
7) Press the following keys and confirm the message:
# key > 1 key >1 key
Message: #PRINT SW 011 00000000
8) Position the cursor to Bit-1 (second from right) using the + or - key, and
press the 1 key, and then confirm the following message:
Message: #PRINT SW 011 0000001
0
9) Press the OK key. Confirm that "SW 011" changes to "SW 012".
Message: #PRINT SW 012 00000000
10) Press the Reset key to exit the service mode.
11) Close the front cover. The machine will run in the developer idling mode
for about 1 minute.
12) When the machine stops, the idling mode ends.
Install, the toner cartridge following the above-mentioned procedure.
2.2.4 Setting the Cassettes
0011-1073
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Holding the knob [1] at the center of the cassette, draw out the cassette [2]
until it stops.
F-2-21
2) Remove the wire [1] securing the inner plate of the cassette.
F-2-22
3) Press the "PUSH DOWN" mark [1] on the inner plate to lock it into the
cassette.
F-2-23
4) Turn the lever [1] of the paper front guide counterclockwise to release it.
Slide the paper front guide [2] to fit to the size of the paper to be used, and
then turn the lever clockwise to lock it.
F-2-24
[1]
[2]
[1]
PUSH DOWNPUSH DOWN
[1]
A3
A4
A4
A5
B5
LTR
STMT
B4
B5
11 17
LTR
U1
U2
U3
LGL
[1]
[2]